Ø320 x 80mm
Our New Tri Colour 2D Bulkhead comes with 3 selectable colour Temperatures giving you the choice of 3000k, 4000k or 5000k. Comes in either Standard Version or Microwave, 3Hr Emergency, 3Hr Emergency + Microwave and Photocell.
· Lumens – 1100lm
· IK Rating – IK08
Emergency - The self-contained emergency version will switch over automatically when the mains supply fails and provide up to 3 hours operation. A permanent live feed is required in addition to the switched live and neutral supply.
Microwave - Detection angle: 180° Detection range: 1-8m, adjustable Time delay: 8sec to 12min, adjustable
Photocell - Operation is exactly the same as the Microwave sensor (above) but dims down to a preset level and time dependent upon the user settings programmed at time of installation.
Settings – there are 3 settings which can be adjusted turning the dials
Sensitivity - y Use this dial to adjust the range sensitivity which decides how close motion has to be to the sensor before the light will activate, after mounting the light at a height of 2.5m. Turn the dial fully anticlockwise to select minimum reach (approx.1 m distance), and fully clockwise to select maximum distance (approx. 10m)
Time - The light can be set to stay ON for any period of time between approx. 8sec (turn fully anticlockwise) and a maximum of 12min (turn fully clockwise). Any movement detected before this time elapse will re-start the timer. It is recommended to select the shortest time for adjusting the detection zone when performing a walk test.
LUX - Use the lux dial to set how dark it is before the light will start to activate. Turn it fully anticlockwise to select dusk- to-dawn operation at about 10 lux. Turn it fully clockwise to select daylight operation at about 2000lux. The dial must be turned fully clockwise when adjusting the detection range and performing the walk test in daylight.